מדינה: אוסטרליה
שפה: אנגלית
מקור: APVMA (Australian Pesticides and Veterinary Medicines Authority)
COPPER PRESENT AS CUPROUS THIOCYANATE; DIURON
PPG INDUSTRIES AUSTRALIA PTY LIMITED
Cu as CuCNS(172g/L)+diuron(65g/L)
PAINT
COPPER PRESENT AS CUPROUS THIOCYANATE CYANIDE Active 172.0 g/L; DIURON UREA-SUBSTITUTED Active 65.0 g/L
Black 10L; Black 4L; Blue 10L; Blue 4L
A - Agricultural
PPG INDUSTRIES
BOAT - EXTERIOR (ANTIFOULING)
ANTIFOULING
MARINE GROWTH | BARNACLES | FRESH-WATER FOULING ORGANISMS | MARINE FOULING ORGANISMS | MUSSELS
Poison schedule: 0; Withholding period: WHP: N/A; Host/pest details: BOAT - EXTERIOR (ANTIFOULING): [MARINE GROWTH]; Poison schedule: 0; Withholding period: ; Host/pest details: BOAT - EXTERIOR (ANTIFOULING): [MARINE GROWTH]; A single-pack, tin free antifouling.
Stopped
2023-07-01
File Name 64189_47780_4L_BLUE_MPL_V02.pdf Dimensions 572mm x 184mm Scale A3 71% Date 19/10/09 M179808G BEFORE USING REFER TO MATERIAL SAFETY DATA SHEET, ALSO TECHNICAL DATA SHEET, OBTAINABLE FROM PPG INDUSTRIES AUSTRALIA PTY LIMITED. FOLLOW ALL DIRECTIONS AND WARNINGS FULLY AND CAREFULLY. OTHERWISE DO NOT USE THIS PRODUCT. M179808G / O294309G READ SAFETY DIRECTIONS BEFORE OPENING OR USING 30001-BLUEZ9 BLUE 4 LITRES ECOFLEET ALLOY ANTIFOULING DIRECTIONS FOR USE BATCH NO. 9 325474 247173 O294309G ACTIVE CONSTITUENT: 172 g/L COPPER present as Cuprous Thiocyanate 65 g/L DIURON A Single-Pack, tin free Antifouling PPG Industries Australia Pty Limited, McNaughton Road, Clayton, Victoria 3168 Australia NOT TO BE USED FOR ANY PURPOSE, OR IN ANY MANNER, CONTRARY TO THIS LABEL UNLESS AUTHORISED UNDER APPROPRIATE LEGISLATION. DIRECTIONS FOR USE: The success of an antifouling job depends on the dry film build applied, which has a direct effect on the life expectancy. Irrespective of how this product is applied, it is the owner’s responsibility to ensure that the total nominated film thickness is achieved. Depending upon method of application and prevailing conditions, multiple coats may be necessary. The preferred method of application is by spray. APPLICATION: Ensure surface is dry and free from any contamination and sufficiently roughened if necessary. Substrate temperature must be at least 3˚C above dew point. Each coat may be applied at 75 microns dry film (150 microns wet film) and usually 2 coats are required to protect the vessel during a 12–24 month period (Spray application only – brush and roller coats are thinner and the number of coats required needs to be increased to account for thinner coats). METHOD OF APPLICATION: Spray gun (use respiratory protection), brush or roller. STIR WELL BEFORE AND DURING USE. Use over a suitable high level – performance anti-corrosive coating such as the Wattyl recommended coal-tar epoxy, epoxy, chlorinated rubber, or vinyl tar. LAUNCHING: Allow a minimum of 10 hours (at 20 קרא את המסמך השלם