MARCAINE SPINAL 0.5 % HEAVY

Quốc gia: Israel

Ngôn ngữ: Tiếng Anh

Nguồn: Ministry of Health

Thành phần hoạt chất:

BUPIVACAINE HYDROCHLORIDE

Sẵn có từ:

PADAGIS ISRAEL AGENCIES LTD, ISRAEL

Mã ATC:

N01BB01

Dạng dược phẩm:

SOLUTION FOR INJECTION

Thành phần:

BUPIVACAINE HYDROCHLORIDE 5 MG/ML

Tuyến hành chính:

SPINAL

Loại thuốc theo toa:

Required

Sản xuất bởi:

CENEXI , FRANCE

Nhóm trị liệu:

BUPIVACAINE

Khu trị liệu:

BUPIVACAINE

Chỉ dẫn điều trị:

Spinal anaesthesia for surgery, e.g. urological and lower limb surgery, lasting 2-3 hours, abdominal surgery lasting 45-60 minutes.

Ngày ủy quyền:

2014-09-30

Đặc tính sản phẩm

1
SUMMARY OF PRODUCT CHARACTERISTICS
1. NAME OF THE MEDICINAL PRODUCT
Marcaine Spinal 0.5% Heavy
2. QUALITATIVE AND QUANTITATIVE COMPOSITION
_1 ml solution for injection contains_
: 5 mg bupivacaine hydrochloride.
For the full list of excipients, see section 6.1.
3.
PHARMACEUTICAL FORM
Solution for injection
4.
CLINICAL PARTICULARS
4.1.
Therapeutic indications
Spinal anaesthesia for surgery, e.g. urological and lower limb
surgery, lasting 2-3 hours,
abdominal surgery lasting 45-60 minutes.
4.2.
Posology and method of administration
Marcaine Spinal Heavy should only be used by physicians with
experience of regional
anaesthesia or under the supervision of such a physician. The lowest
possible dose for
adequate anaesthesia should be sought.
The doses given below are guidelines for adults and the dose must be
adjusted for the
individual patient.
The dose must be reduced in the elderly and patients in the late
stages of pregnancy.
Indication
Dose
ml
Dose
mg
Onset time
minutes
(approx.)
Duration
hours
(approx.)
Urological
surgery
1.5-3 ml
7.5-15 mg
5-8 min
2-3 hours
Surgery in the lower
extremities, including
hip surgery
2-4 ml
10-20 mg
5-8 min
2-3 hours
Abdominal surgery
(including caesarean
section)
2-4 ml
10-20 mg
5-8 min
45-60 min
The recommended injection is in the L3-L4 intervertebral space.
There is currently no clinical experience of doses higher than 20 mg.
A spinal injection must not be given until the subarachnoid space has
been clearly identified
via lumbar puncture (clear cerebrospinal fluid exits via the spinal
needle or is seen on
aspiration). In the case of failed anaesthesia, only one new attempt
should be made to
administer the medicinal product, which should be given at a different
level and with a
2
smaller volume. One reason for lack of effect may be poor intrathecal
distribution of the
medicinal product, which may be rectified by adjusting the position of
the patient.
4.3.
Contraindications
Hypersensitivity to the active substance, amide-type local
anaesthetics or to any of the
excipients listed i