Nchi: Australia
Lugha: Kiingereza
Chanzo: APVMA (Australian Pesticides and Veterinary Medicines Authority)
COPPER PRESENT AS COPPER OXYCHLORIDE; SULPHUR
GROCHEM AUSTRALIA PTY LTD
Cu as oxychloride(159g/kg)+sulfur(546g/kg)
WATER DISPERSIBLE GRANULE
COPPER PRESENT AS COPPER OXYCHLORIDE MINERAL-COPPER Active 159.0 g/kg; SULPHUR MINERAL-SULPHUR Active 546.0 g/kg
1kg-25kg
A - Agricultural
GRAPEVINE
FUNGICIDE
DOWNY MILDEW | POWDERY MILDEW
Poison schedule: 5; Withholding period: WHP: DO NOT Harvest crops for 30 days post appliation.; Host/pest details: GRAPEVINE: [DOWNY MILDEW, POWDERY MILDEW]; For the control of various fungal diseases of grape vinesRESTRAINTS, etc: See Label.
Registered
2023-07-01
Page 1 of 3 MILDEX WG FUNGICIDE 64640/115552 Product Name: APVMA Approval No: Label Name: MILDEX WG FUNGICIDE Signal Headings: CAUTION KEEP OUT OF REACH OF CHILDREN READ SAFETY DIRECTIONS BEFORE OPENING OR USING Constituent Statements: ACTIVE CONSTITUENTS: 159 g/kg COPPER (Cu) PRESENT AS COPPER OXYCHLORIDE 546 g/kg SULPHUR Mode of Action: GROUP M1 M2 FUNGICIDE Statement of Claims: A fine dry flowable fungicide for the control of various fungal diseases on grape vines as per the Directions for Use table. Net Contents: 1 KG TO 25 KG Restraints: RESTRAINTS: DO NOT apply product in combination with spraying oil. DO NOT spray this product when hot conditions (30°C) or frosts are likely to occur as damage can result. DO NOT apply to sulphur shy varieties. DO NOT apply to copper shy varieties. DO NOT apply to wet foliage. DO NOT use this product during poor drying conditions. Directions for Use: This section contains file attachment. Other Limitations: RLP APPROVED Page 2 of 3 Withholding Periods: DO NOT HARVEST CROPS FOR 30 DAYS AFTER APPLICATION. Trade Advice: General Instructions: GENERAL INSTRUCTIONS APPLICATION HIGH VOLUME (DILUTE SPRAYING) Mix specified rates of product per 100L water, and apply in sufficient water to thoroughly wet the crop to the point of run-off. The water volume should increase as the crop size and bulk increases. LOW VOLUME (CONCENTRATE SPRAYING) Apply in sufficient water to ensure thorough, even coverage of all plant parts. The rate of product applied per hectare should be based on that which would be applied per hectare if high volume (dilute) application was used. SPECIAL INSTRUCTIONS FOR TREE AND VINE CROPS Dilute Spraying Use a sprayer designed to apply high volumes of water up to the point of run-off and matched to the crop being sprayed. Set up and operate the sprayer to achieve even coverage throughout the crop canopy. Apply sufficient water to cover the crop to the point of run-off. Avoid excessive run-off. The required water volume may be determined by applying different test volum Soma hati kamili
Page 1 of 7 Melpat Mildex / MP100 MSDS MILDEX® (MP100) MATERIAL SAFETY DATA SHEET 1. COMPOSITION / INFORMATION ON INGREDIENTS Chemical Name : Homogeneous mixture of Sulfur and Copper Oxychloride Common Name : Mildex / MP100 Chemical Formula : N/A Molecular Weight Sulfur : 32.06 Molecular Weight Copper Oxychloride : 427.13 Composition : 54.600% Sulfur (s) and 15.90% Cu as copper (Cu) CAS No Sulfur : 7704 34 – 9 CAS No Copper Oxichloride : 1332 – 40 7 UN No : 3077 Class : 9 2. HAZARDS IDENTIFICATION Product hazards classification : Hazardous to people’s health Effects of acute overexposure (one time only) : n/a Inhalation (sulphur powder) : May cause coughing, tracheal burning sensation & could cause lung edema & breathing distress Skin Contact : May cause skin irritation Eye Contact : May cause eye irritation resulting in tearing & possible conjunctivitis Ingestion : Abdominal pain, nausea, vomiting & diarrhea Effects of chronic exposure (long- term) : May result in respiratory & ophthalmologic disorders, in addition to bronchitis & chronic sinusitis Page 2 of 7 Melpat Mildex / MP100 MSDS HAZARDS IDENTIFICATION (CONT’D) Hazards to the environment : Lengthy exposure of product on soils & vegetation may cause harm. Potential risks due to contamination are low if product is used at recommended doses & properly applied Product’s special hazards : Hydrogen sulfur may be released from sulfur decomposition & may cause depression of the central nervous system, resulting in headache, nausea, vertigo, salivation, loss of consciousness & death 3. FIRST AID MEASURES If accidental contact with product occurs, proceed as follows: Inhalation : Remove victim from exposure source. If victim is affected by sulfur decomposition products, remove immediately to open air and seek medical attention If breathing is irregular, apply artificial respiration & administer oxygen at 100%, as needed. Skin Contact : Remove contaminated clothes and wash affected area with abundant water and soap. If irritation persists, seek medical at Soma hati kamili
CAUTION KEEP OUT OF REACH OF CHILDREN READ SAFETY DIRECTIONS BEFORE OPENING OR USING ACTIVE CONSTITUENT: 159 G/KG COPPER (CU) PRESENT AS COPPER OXYCHLORIDE 546 G/KG SULPHUR A FINE DRY FLOWABLE FUNGICIDE FOR THE CONTROL OF VARIOUS FUNGAL DISEASES ON GRAPE VINES AS PER THE DIRECTIONS FOR USE TABLE. MILDEX FUNGICIDE 15 KG PAGE 1 OF 3 Suite 1, Lvl 3, 262, Lorimer Street, Port Melbourne, VIC 3207 1800 777 068 GROCHEM.COM CONTENTS 15 KG FUNGICIDE GROUP FUNGICIDE MILDEX WG SPECIMAN PAGE 2 OF 3 DIRECTIONS FOR USE RESTRAINTS: DO NOT apply product in combination with spraying oil. DO NOT spray this product when hot conditions (30°C) or frosts are likely to occur as damage can result. DO NOT apply to sulphur shy varieties. DO NOT apply to copper shy varieties. DO NOT apply to wet foliage. DO NOT use this product during poor drying conditions. NOT TO BE USED FOR ANY PURPOSE, OR IN ANY MANNER, CONTRARY TO THIS LABEL UNLESS AUTHORISED UNDER APPROPRIATE LEGISLATION. WITHHOLDING PERIODS: DO NOT HARVEST CROPS FOR 30 DAYS AFTER APPLICATION. CROP DISEASES STATE RATE CRITICAL COMMENTS RATE In the following table all rates given are for dilute spraying. For concentrate spraying, refer to the Application section in the GENERAL INSTRUCTIONS. For all uses in this table: Apply as a dilute spray that results in a visible wetting of buds and foliage and use in conjunction with a wetter such as SST Vitiwet. Treatments will be less effective and may be phytotoxic if applied as a concentrate. In the case of a concentrated spray application, then apply the same total amount of product to the target foliage. Crop phytotoxicity may occur when application occurs during hot or humid (>75% RH) conditions, or when the vines are suffering from moisture stress. Do not apply during the heat of the day. Ensure thorough coverage. Grape Vines Downy Mildew (_Plasmopara _ _viticola_) All States 300g – 400g per 100 litres OR 3 – 4kgs per hectare Apply sprays as close as possible before conditions favour downy mildew from when shoots are 3-5 cm long. Rep Soma hati kamili