Nchi: Australia
Lugha: Kiingereza
Chanzo: APVMA (Australian Pesticides and Veterinary Medicines Authority)
THIRAM; COPPER PRESENT AS CUPROUS OXIDE
RESENE PAINTS (AUSTRALIA) LIMITED
PAINT
THIRAM CARBAMATE-DITHIOCARBAMATE Active 44.0 g/L; COPPER PRESENT AS CUPROUS OXIDE MINERAL-COPPER Active 764.0 g/L
10 L; 4 L
A - Agricultural
ANTIFOULING
Poison schedule: 6; Withholding period: ; Host/pest details: COMMERCIAL VESSEL(STEEL,TIMBER,FIBREGLAS: [MARINE GROWTH]
Registered
2023-07-01
Page 1 of 3 Altex Yacht & Boat Paint No.5 Plus Antifouling 86349/115543 Product Name: APVMA Approval No: Label Name: Altex Yacht & Boat Paint No.5 Plus Antifouling Signal Headings: POISON KEEP OUT OF REACH OF CHILDREN READ SAFETY DIRECTIONS BEFORE OPENING OR USING Constituent Statements: 764 g/L COPPER present as cuprous oxide 44 g/L THIRAM Statement of Claims: AN ABLATIVE ANTIFOULING FOR USE ON SUITABLY PREPARED STEEL, FIBREGLASS, FERROCEMENT AND WOODEN HULLS Net Contents: 4 L 10 L Directions for Use: RESTRAINTS: DO NOT use on aluminium hulls or stern drives SURFACE PREPARATION: ALTEX No.5 Plus Antifouling paint is designed to overcoat Altex Yacht & Boat Bottom Systems. ALTEX No.5 Plus Antifouling is compatible with a wide range of anticorrosive and antifouling paints. Its use over products other than Altex Yacht & Boat Bottom Systems should be referred to Resene Paints (Australia) Limited for specific recommendations. If ALTEX No.5 Plus Antifouling is applied over an epoxy hull coating, it must be applied before the epoxy has fully cured hard, ie when the epoxy is tack free but still soft to finger nail pressure. For the repainting of existing antifouling and to facilitate bottom cleaning we recommend high pressure water blast cleaning (5000 psi minimum) and wash with ALTEX P40 Pre-Painting Cleaner diluted 1 part to 10 parts water. It is recommended that after 3-4 repaints that the old antifouling coatings be removed and then repaint the hull with Altex Yacht & Boat Bottom System and ALTEX No.5 Plus Antifouling as above. Other Limitations: NOT TO BE USED FOR ANY PURPOSE, OR IN ANY MANNER, CONTRARY TO THIS LABEL UNLESS AUTHORISED UNDER APPROPRIATE LEGISLATION RLP APPROVED Page 2 of 3 General Instructions: MIXING AND THINNING: Stir thoroughly before use. ALTEX No.5 Plus Antifouling does not require thinning, except possibly in hot windy conditions. If thinned, additional coats may be required to attain correct film thickness. Film thickness is critical to the performance of the coating. APPLICATION: Apply two coa Soma hati kamili