Материал стоматологический пломбировочный и вспомогательные изделия к ним:

Страна: Беларусь

Язык: русский

Источник: Министерством здравоохранения Республики (Центр экспертиз и испытаний в здравоохранении)

Доступна с:

GC Europe N.V., БЕЛЬГИЯ

класс:

изделия медицинского назначения

Производитель:

GC Europe N.V.

Дата Авторизация:

2021-10-07

Характеристики продукта

GC FUJI
TM
II LC (IMPROVED)
RADIOPAQUE LIGHT CURED REINFORCED GLASS IONOMER
RESTORATIVE
For use only by a dental professional in the recommended
indications.
RECOMMENDED INDICATIONS
1. Class
III
and
V
restorations, particularly for cervical erosions
and root surface caries.
2. Restoration of primary teeth.
3. Core build up.
4. Cases where radiopacity is required.
5. Geriatric applications.
6. As a base or liner.
CONTRAINDICATIONS
1. Pulp capping.
2. Avoid use of this product in patients with known allergies to glass
ionomer cement, methacrylate monomer or methacrylate
polymer.
DIRECTIONS FOR USE
1. POWDER AND LIQUID DISPENSING
a) Select shade based on Vita® shade guide.
® : Vita is a registered trademark of Vita Zahnfabrik, Bad
Säckingen, Germany.
b) The standard powder to liquid ratio is 3.2g / 1.0g. 1 level scoop
of powder to 2 drops of liquid.
c) For accurate dispensing of powder, tap the bottle gently.
Do not shake or invert.
d) Hold the liquid bottle vertically and squeeze gently.
e) Close bottles immediately after use.
2. MIXING
a) Fluff powder of bottle before dispensing (Fig. 1).
b) Place one scoop of powder and two drops of liquid on pad.
Divide powder in half (Fig. 2).
c) Spread liquid out into a thin layer (about the size of a half
dollar
or 3 cm) with plastic spatula (Fig. 3).
d) Pull half of the powder onto liquid and mix with lapping strokes
(like impression material) for 10 to 15 seconds (Fig. 4).
e) Pull in remaining powder and mix thoroughly to a glossy
consistency. Do not exceed 20-25 second total mixing time
(Fig. 5).
3. RESTORATIVE TECHNIQUE
a) Prepare tooth using standard techniques. Extensive
mechanical retention is not necessary. For pulp capping use
calcium hydroxide.
b) Apply CAVITY CONDITIONER (10 seconds) or DENTIN
CONDITIONER (20 seconds) to the bonding surfaces using a
cotton pellet or sponge.
c) Rinse thoroughly with water. Dry by blotting with a cotton
pellet or gently blowing with an air syringe. DO NOT
DESICCATE. Best results are obtained when prepared
surfaces appear moist (gl