Пластмасса стоматологическая: для перебазировки:

Valsts: Baltkrievija

Valoda: krievu

Klimata pārmaiņas: Министерством здравоохранения Республики (Центр экспертиз и испытаний в здравоохранении)

Pieejams no:

GC Europe N.V., БЕЛЬГИЯ

Klase:

изделия медицинского назначения

Ražojis:

GC Europe N.V.

Autorizācija datums:

2021-10-07

Produkta apraksts

594
250mm
TEMPORARY CROWN AND BRIDGE RESIN
For use only by a dental professional in the recommended indications.
RECOMMENDED INDICATIONS
For the preparation of temporary crowns, bridges or dentures.
Space maintenance.
CONTRAINDICATIONS
Avoid use of this product in patients with known allergies to
methacrylate
monomer or methacrylate polymer.
DIRECTIONS FOR USE
A. CROWNS
1. PREPARATION
a) Fill defects in the tooth with CAVITON or equivalent temporary
filling
material.
b) Take an impression using a heavy (i.e. less water) alginate
impression
material. Wrap the impression in wet gauze to prevent distortion.
c) Prepare the tooth to be crowned.
d) Cut V notches in the impression from gingival to buccal and lingual
sides to allow escape of excess resin.
2. MIXING
a) The standard powder/liquid ratio is 1.0 g/0.5 mL (up to the first
graduation on the powder measure and the first graduation of the
liquid pipette).
Note:
To minimize shrinkage use as little liquid as possible.
b) Measure the liquid into the mixing jar, and slowly add the
corresponding quantity of powder. Mix for 20-30 seconds.
3. APPLICATION
a) Pour the creamy paste into the prepared impression, and seat
tightly
in the mouth.
b) After 3 minutes in the mouth remove the impression, leaving the
dough like resin on the tooth.
c) Remove the resin crown before it is fully set and dip in and out of
hot
water (approximately 50°C/122°F) several times in order to prevent
shrinkage.
d) Trim any excess using a bur and then polish.
e) Cement the temporary crown in position using FREEGENOL
TEMPORARY PACK or other appropriate temporary cement.
B. BRIDGES
1. PREPARATION
a) Select a suitable artificial tooth and fix between the abutment
teeth
using a suitable wax. Check the bite.
b) Take a full arch impression using an alginate impression material.
Carefully remove the pontic and wrap the impression in wet gauze.
c) Prepare the abutment teeth as appropriate.
Subsequent procedures are carried out as described above for
crowns A. 1 (a) to A. 3 (e).
STORAGE
Recommended for o