Pays: Canada
Langue: anglais
Source: Health Canada
IODINE (POLYETHOXY POLYPROPOXY POLYETHOXY ETHANOL - IODINE COMPLEX)
PRODUCERS AGRI-SUPPLY LTD.
1%
SOLUTION
IODINE (POLYETHOXY POLYPROPOXY POLYETHOXY ETHANOL - IODINE COMPLEX) 1%
TOPICAL
18.9/56.8//208/1041L
OTC
CATTLE
Active ingredient group (AIG) number: 0103970003
APPROVED
2014-02-06
Producers Agri-Supply December 13, 2023 _MAIN PANEL _ PRODUCERS AGRI-SUPPLY DIN 02420899 VETERINARY USE ONLY TEAT SUPREME 110 IODINE TEAT SOLUITION POST-MILKING ANTISEPTIC TEAT SOLUTION WARNINGS: No meat withdrawal period or milk withholding time is required when used according to the label. Avoid contact with food. Do not take internally. If accidentally ingested, drink large volumes of water. Avoid contact with skin and eyes. If accidental contact occurs, flush thoroughly with running water. Seek medical attention immediately after oral exposure or contact with skin and eyes. Avoid breathing vapours. Do not use for cleaning and/or sanitizing milking equipment. Keep out of reach of children. ACTIVE INGREDIENTS: Iodine (from Polyethoxy Polypropoxy Polyethoxy Ethanol – Iodine Complex), 1.0% w/w EMOLLIENTS: Glycerin, 8.0% w/w, Propylene Glycol, 1.0% w/w, Lanolin (as ethoxylated lanolin), 2.0% w/w _SIDE PANELS _ INDICATIONS: TEAT SUPREME 110 is a post-milking antiseptic teat solution to be used as an aid in reducing the spread of organisms which may cause mastitis in dairy cattle. DIRECTIONS FOR USE: POST-MILKING: Use at full strength, do not dilute . Apply TEAT SUPREME 110 to each teat immediately after milking. Ensure that the solution thoroughly covers the entire surface of all teats. Allow teats to dry. Do not wipe. If outside temperature is below 0⁰C, allow to air dry on the teats before turning cows out to cold weather to prevent freezing. When a cow is being dried off, continue the application of TEAT SUPREME 110 to all teats once daily for 1 to 2 weeks as required after the last milking. With freshening cows, resume application of TEAT SUPREME 110 to all teats twice daily for 7 to 10 days before calving. A fresh solution should always be used at each milking. The application equipment should be cleaned and rinsed properly after each milking session or when the solution becomes contaminated. Do not pour remaining solution back into the original container. Keep container closed to prevent contamination of Lire le document complet