VALIANT SHIELD- lactic acid and heptanoic acid solution

Country: United States

Language: English

Source: NLM (National Library of Medicine)

Active ingredient:

LACTIC ACID (UNII: 33X04XA5AT) (LACTIC ACID - UNII:33X04XA5AT), HEPTANOIC ACID (UNII: THE3YNP39D) (HEPTANOIC ACID - UNII:THE3YNP39D)

Available from:

ABS Global Inc.

INN (International Name):

LACTIC ACID

Composition:

LACTIC ACID 14.27 mg in 1 mL

Administration route:

TOPICAL

Prescription type:

OTC

Therapeutic indications:

DIRECTIONS FOR USE Mix Directions: Add 3.5 ounces of Valiant Catalyst (US) to one gallon of Valiant Shield and mix. Inverting the container approximately 5-7 times will adequately mix the two solutions. This mixed solution will remain stable for 7 days. After 7 days, discard solution and mix a new solution. IMPORTANT: Do not add mixed Valiant Shield ready-to-use to any other teat dip or other products. If transferred from this container to any other, make sure the other container is thoroughly pre-cleaned and bears the proper container labeling for Valiant Shield. Use of a complete cow-care program including both pre and post dipping may aid in reducing the spread of organisms which may cause mastitis. DIRECTIONS FOR TEAT DIPPING Post-Milking: Immediately after milking, use the mixed Valiant Shield solution at full strength. Submerge the teat 2/3 of its length in the solution. Allow to air dry. Do not wipe. Always use mixed, uncontaminated, full strength solution. If product in dip cup becomes visibly dirt

Authorization status:

unapproved drug other

Summary of Product characteristics

VALIANT SHIELD- LACTIC ACID AND HEPTANOIC ACID SOLUTION
ABS GLOBAL INC.
_Disclaimer: This drug has not been found by FDA to be safe and
effective, and this labeling has not been_
_approved by FDA. For further information about unapproved drugs,
click here._
----------
KEEP OUT OF REACH OF CHILDREN
NOT FOR HUMAN USE
WARNING
Causes eye irritation.
Wash skin thoroughly after handling. Do not mix with bleach or other
chlorinated products - will cause
chlorine gas. For external use on dairy cows.
DIRECTIONS FOR USE
MIX DIRECTIONS: Add 3.5 ounces of Valiant Catalyst (US) to one gallon
of Valiant Shield and mix.
Inverting the container approximately 5-7 times will adequately mix
the two solutions. This mixed
solution will remain stable for 7 days. After 7 days, discard solution
and mix a new solution.
IMPORTANT: Do not add mixed Valiant Shield ready-to-use to any other
teat dip or other products. If
transferred from this container to any other, make sure the other
container is thoroughly pre-cleaned and
bears the proper container labeling for Valiant Shield.
Use of a complete cow-care program including both pre and post dipping
may aid in reducing the
spread of organisms which may cause mastitis.
DIRECTIONS FOR TEAT DIPPING
POST-MILKING: Immediately after milking, use the mixed Valiant Shield
solution at full strength.
Submerge the teat 2/3 of its length in the solution. Allow to air dry.
Do not wipe. Always use mixed,
uncontaminated, full strength solution. If product in dip cup becomes
visibly dirty, discard contents and
replenish with undiluted product. Do not turn cows out in the freezing
weather until Valiant Shield is
completely dry. Wash teats thoroughly just prior to next milking with
appropriate udder wash solution
or pre-milking teat dip. Teats should then be dried with a
single-service towel. Use proper procedures
for udder washing or pre-dipping.
NOTE: Valiant Shield is not intended to cure or help in the healing of
chapped or irritated teats. In case
of irritation or chapping, have the condition examined an