Χώρα: Λευκορωσία
Γλώσσα: Ρωσικά
Πηγή: Министерством здравоохранения Республики (Центр экспертиз и испытаний в здравоохранении)
GC Europe N.V., БЕЛЬГИЯ
изделия медицинского назначения
GC Europe N.V.
2021-10-07
GC FUJI TM II LC (IMPROVED) RADIOPAQUE LIGHT CURED REINFORCED GLASS IONOMER RESTORATIVE For use only by a dental professional in the recommended indications. RECOMMENDED INDICATIONS 1. Class III and V restorations, particularly for cervical erosions and root surface caries. 2. Restoration of primary teeth. 3. Core build up. 4. Cases where radiopacity is required. 5. Geriatric applications. 6. As a base or liner. CONTRAINDICATIONS 1. Pulp capping. 2. Avoid use of this product in patients with known allergies to glass ionomer cement, methacrylate monomer or methacrylate polymer. DIRECTIONS FOR USE 1. POWDER AND LIQUID DISPENSING a) Select shade based on Vita® shade guide. ® : Vita is a registered trademark of Vita Zahnfabrik, Bad Säckingen, Germany. b) The standard powder to liquid ratio is 3.2g / 1.0g. 1 level scoop of powder to 2 drops of liquid. c) For accurate dispensing of powder, tap the bottle gently. Do not shake or invert. d) Hold the liquid bottle vertically and squeeze gently. e) Close bottles immediately after use. 2. MIXING a) Fluff powder of bottle before dispensing (Fig. 1). b) Place one scoop of powder and two drops of liquid on pad. Divide powder in half (Fig. 2). c) Spread liquid out into a thin layer (about the size of a half dollar or 3 cm) with plastic spatula (Fig. 3). d) Pull half of the powder onto liquid and mix with lapping strokes (like impression material) for 10 to 15 seconds (Fig. 4). e) Pull in remaining powder and mix thoroughly to a glossy consistency. Do not exceed 20-25 second total mixing time (Fig. 5). 3. RESTORATIVE TECHNIQUE a) Prepare tooth using standard techniques. Extensive mechanical retention is not necessary. For pulp capping use calcium hydroxide. b) Apply CAVITY CONDITIONER (10 seconds) or DENTIN CONDITIONER (20 seconds) to the bonding surfaces using a cotton pellet or sponge. c) Rinse thoroughly with water. Dry by blotting with a cotton pellet or gently blowing with an air syringe. DO NOT DESICCATE. Best results are obtained when prepared surfaces appear moist (gl Διαβάστε το πλήρες έγγραφο