Australia - English - APVMA (Australian Pesticides and Veterinary Medicines Authority)
APVMA Approval No:
88895 / 122770
KEEP OUT OF REACH OF CHILDREN
READ SAFETY DIRECTIONS BEFORE OPENING OR USING
667 g/L prosulfocarb
14 g/L diflufenican
Mode of Action:
Statement of Claims:
For the control of Annual Ryegrass (Lolium rigidum) in Wheat and Barley.
5 - 25 L
This section contains file attachment.
Directions for Use:
This section contains file attachment.
Harvest: NOT REQUIRED WHEN USED AS DIRECTED
Grazing: DO NOT GRAZE OR CUT FOR STOCK FOOD FOR 10 WEEKS AFTER
This section contains file attachment.
JURA Herbicide is a member of the thiocarbamates and nicotinanalide group of herbicides.
This product acts by inhibiting fat and carotenoid synthesis. For weed resistance
management, this product is a Group J and F herbicide. Some naturally occurring weed
biotypes resistant to this product and other Group J and F herbicides may exist through
normal genetic variability in any weed population. The resistant individuals can eventually
dominate the weed population if these herbicides are used repeatedly. These resistant
weeds will not be controlled by this product or other Group J and F herbicides. Since the
occurrence of resistant weeds is difficult to detect prior to use, Globachem n.v. accepts
no liability for any losses that may result from the failure of this product to control resistant
weeds. Advice as to strategies and alternative treatments that can be used should be
obtained from your local supplier, consultant, local Department of Agriculture, Primary
Industries Department or Globachem n.v. representative.
DO NOT enter treated areas until spray has dried. If prior entry is necessary wear cotton
overalls buttoned to the neck and wrist (or equivalent clothing) and chemical resistant
gloves. Clothing must be laundered after each day's use.
PROTECTION OF WILDLIFE, FISH, CRUSTACEANS AND ENVIRONMENT
Very toxic to aquatic life. DO NOT contaminate wetlands or watercourses with this product
or used containers.
PROTECTION OF CROPS, NATIVE AND OTHER NON-TARGET PLANTS
Toxic to flora. DO NOT apply or drain or flush equipment on or near native or non-target
trees or other plants or on areas where their roots may extend or in locations where the
chemical may be washed or moved into contact with their roots.
Triple-rinse containers before disposal. Add rinsings to spray tank. Do not dispose of
undiluted chemicals on site. If recycling, replace cap and return clean containers to recycler
or designated collection point. If not recycling, break, crush, or puncture and deliver empty
packaging to an approved waste management facility. If an approved waste management
facility is not available, bury the empty packaging 500 mm below the surface in a disposal
pit specifically marked and set up for this purpose, clear of waterways, desirable vegetation
and tree roots, in compliance with relevant local, state or territory government regulations.
Do not burn empty containers or product.
Will irritate the eyes and skin. Repeated exposure may cause allergic disorders. Sensitive
workers should use protective clothing. Avoid contact with eyes and skin. When opening
the container and preparing product for use and using the product, wear cotton overalls
buttoned to the neck and wrist (or equivalent clothing) and elbow length chemical resistant
gloves. In addition, when mixing and loading, wear face shield or goggles and a disposable
mask, covering mouth and nose. If product on skin, immediately wash with soap and water.
If product in eyes, wash it out immediately with water. Wash hands after use. After each
day’s use, wash gloves, face shield or goggles and contaminated clothing.
First Aid Instructions:
If poisoning occurs, contact a doctor or Poisons Information Centre. Phone Australia
131126; New Zealand 0800 764 766.
First Aid Warnings:
DO NOT apply by aircraft
DO NOT use in seeding/tillage systems that cannot ensure accurate seed placement and
adequate spatial separation of seed and herbicide.
DO NOT apply more than 3.0 L/ha per single growing season.
DO NOT sow susceptible crops within 9 months of herbicide application.
DO NOT apply if heavy rains or storms are forecast within 3 days of application.
DO NOT irrigate to the point of runoff for at least 3 days after application.
SPRAY DRIFT RESTRAINTS
Specific definitions for terms used in this section of the label can be found at
DO NOT allow bystanders to come into contact with the spray cloud
DO NOT apply in a manner that may cause an unacceptable impact to native vegetation,
agricultural crops, landscaped gardens and aquaculture production, or cause contamination
of plant or livestock commodities, outside the application site from spray drift. The buffer
zones in the relevant buffer zone table/s below provide guidance but may not be sufficient in
all situations. Wherever possible, correctly use application equipment designed to reduce
spray drift and apply when the wind direction is away from these sensitive areas.
DO NOT apply unless the wind speed is between 3 and 20 kilometres per hour at the
application site during the time of application.
DO NOT apply if there are hazardous surface temperature inversion conditions present at
the application site during the time of application. Surface temperature inversion conditions
exist most evenings one to two hours before sunset and persist until one to two hours after
DO NOT apply by a boom sprayer unless the following requirements are met:
Spray droplets are not smaller than a MEDIUM spray droplet size category.
Minimum distances between the application site and downwind sensitive areas are
observed (see ‘Mandatory buffer zones’ section of the following table titled ‘Buffer zones for
Mandatory downwind buffer zones
0.5 m or lower
1.0 m or lower
Directions for Use
NOT TO BE USED FOR ANY PURPOSE, OR IN ANY MANNER, CONTRARY TO THIS
LABEL UNLESS AUTHORISED UNDER APPROPRIATE LEGISLATION
of Group D
Apply pre-emergent and incorporate mechanically by
moist seedbed up to 7
days prior to sowing and
sufficient rain to thoroughly wet the top 3 to 4 cm of soil
should occur within 10 days after spraying. Avoid soil
throw into adjacent seeding rows or sites where furrow
JURA Herbicide is a short residual, soil applied, pre-emergent herbicide that is absorbed by the roots
and shoots (coleoptile) of germinating seedlings with inhibition of growth in the meristematic region.
Foliar uptake is possible but of lower effect. Upstream translocation in the plant occurs but movement
in the phloem is very unlikely. Best activity can be expected from applications before or shortly after the
germination of target weeds.
For pre-emergent application, the product should be applied to a moist smooth seedbed free of soil
clods and emerged weeds. Product efficacy may be reduced by improper incorporation, high levels of
crop or trash residues, stones or foreign matter and in areas of extremely high weed seed density such
as header rows. For optimal efficacy and crop safety in barley and wheat avoid shallow seeding and
repellent soils, soils subject to water logging or where furrow walls are likely to collapse. Duration and
effectiveness of weed control will depend on use rate, soil type and rainfall or irrigation after application.
sufficient available soil moisture to ensure soil movement and uptake by emerging weed seeds.
The selectivity of JURA Herbicide in cereals is a combination of positional and physiological selectivity.
Positional selectivity must be maintained by sowing at adequate depth below the herbicide band. The
physiological selectivity of JURA Herbicide is given by the ability of cereals to metabolise the herbicide
inactive compounds more rapidly than susceptible weed species. Environmental factors such as
rainfall events following application and soil type will influence product movement into the seed zone.
Crop injury may occur when used in sandy soils with high leaching potential or in all soil types when
heavy rainfall is received between sowing and emergence. Crop injury may also result from tank mixes
with other herbicides. Shallow seeding is not recommended due to the greater potential for movement
of herbicide within close proximity of the emerging crop. Conditions resulting in poor root development
or the occurrence of crop stresses including waterlogging, drought, frost, nutrient deficiency or disease
can result in unacceptable crop damage and yield loss as a result of root uptake of herbicide. Risk of
crop damage may be exacerbated where varieties with short coleoptile length are planted in conjunction
with the use of
some fungicide seed treatments. Consult your local agronomist, advisory service or
National Variety Trial (NVT) herbicide tolerance screening results for the latest information of specific
IBS with knife or blade pints: Working speed should ensure adequate incorporation of product but
avoid soil throw into the adjacent seeding row. Use of press wheels will minimise potential for herbicide
to be dragged back into seeding rows. Weed control may be reduced in seeding rows as a result of
concentration of herbicide in crop inter-rows. A knife or blade point is defined as being <12 mm in width,
having no wings, inverted T or blade and is generally on a minimum 200 mm row spacing.
Full disturbance or conventional cultivation, including trailing harrows / prickle chain: Care
should be taken to ensure seed placement below the herbicide band as crop damage may result
where seed is sown too shallow.
PRODUCT MUST BE INCORPORATED INTO THE SOIL WITHIN 7 DAYS OF APPLICATION
JURA Herbicide is an emulsifiable concentrate that mixes readily with water. Fill the spray tank to one
quarter full. Add JURA Herbicide and continue adding water to
make up to the final spray volume.
Agitate while mixing and spraying. When tank mixing wettable powder or water dispersible granule
formulations should be added to the tank first followed by suspension concentrates (flowables), water
soluble salts then JURA Herbicide or other emulsifiable concentrate formulations. Maintain thorough
agitation during mixing and application. Agitate tank mixes vigorously if allowed to stand. Note: Tank
mix spray solutions should NOT be left standing in the vat overnight.
Sprayer Clean Up
After using JURA Herbicide, empty the tank completely and drain the whole system. Thoroughly wash
inside the tank using a pressure hose, drain the tank and clean any filters in the tank, pump, line and
To rinse: After cleaning the tank as above, quarter fill the tank with clean water and circulate through
the pump, lines, hoses and nozzles. Drain and repeat the rinsing procedure twice.
As formulations of other manufacturers’ products are beyond the control of Globachem n.v. and water
quality varies with location, all mixtures should be tested prior to mixing commercial quantities.
DO NOT apply by air.
Apply by ground rig only in a minimum of 50 L water/ha. Water rate selection should be based on soil
type and stubble load. Stubble loads above 40 to 50% ground coverage can reduce weed control below
acceptable levels. Water volumes greater than 70 L/ha are recommended in order to reduce the impact
of stubble in direct drill or minimum tillage systems. Use a nozzle delivering spray quality in the medium
to very coarse spray range.