Australia - English - APVMA (Australian Pesticides and Veterinary Medicines Authority)
Page 1 of 4
KEEP OUT OF REACH OF CHILDREN
READ SAFETY DIRECTIONS BEFORE OPENING OR USING
Active Constituent: 50g/L ALPHA-CYPERMETHRIN
For knockdown and surface residual control of cockroaches,
spiders, silverfish, flies, fleas and ants in Industrial, Commercial,
Domestic and Public Health situations.
Contents 1, 2½,5,20 LITRES
ChemAg Pty Ltd, Suite 12, 11 Preston Street, Como, Western Australia 6152
Phone (08) 9368 7474 Fax (08) 9368 6144
ACN 009 234 691
Page 2 of 4
BUGOFF PC50 RESIDUAL INSECTICIDE
DIRECTIONS FOR USE:
Shake well before use.
Treatment 60 -
Apply as a course low pressure surface
spray to areas where pests hide, frequent
and rest. Spray to the point of runoff using
around 5L of spray mixture/100sq.m. and
ensuring thorough coverage of the treated
surfaces. Where indicated, use the higher
rate in situations where pest pressure is
severe, and where rapid knockdown and/or
maximum residual protection is desired.
Pay particular attention to protected dark
areas such as cracks and crevices, behind
& under sinks, stoves, refrigerators,
furniture, pipes & other known hiding or
Use the initial treatment rate for rapid
knockdown and maximum residual
protection and if necessary, repeat
treatment using the maintenance rate at 12
weekly intervals to prevent infestation.
NOT TO BE USED FOR ANY PURPOSE, OR ANY MANNER, CONTRARY TO THIS
LABEL UNLESS AUTHORISED UNDER APPROPRIATE LEGISLATION
Bugoff PC50 is a powerful knockdown and residual insecticide. Pests are controlled by
direct contact with the spray and also by residual action as they come into contact with
treated surfaces. NOT to be used to control fleas on animals.
MIXING. SHAKE WELL BEFORE OPENING.
This product is to be diluted with water prior to application. To obtain desired volume of
concentrate, loosen cap on measure side of container and slowly squeeze the container
until chamber is filled to the desired level. Remove the chamber cap and pour contents
into suitable mixing container. For best results, make a “premix” of the required amount of
product with an equal volume of water and stir thoroughly. Fill sprayer to half of desired
volume and add “premix”. Agitate thoroughly and then fill sprayer to desired volume and
agitate again to ensure proper mixing. Re-agitate prior to application if spraying is
interrupted. Do not store diluted insecticide. Mix only the amount of insecticide needed for
Apply diluted insecticide by means of a knapsack sprayer or other suitable spraying
equipment capable of delivering a course spray directly onto exposed surfaces frequently
by pests. Spray to the point of runoff ensuring thorough coverage of all treated surfaces.
Page 3 of 4
INSECTICIDE RESISTANCE WARNING
For insecticide resistance management Bugoff PC50 Residual Insecticide is a Group 3A
Some naturally occurring insect biotypes resistant to Bugoff PC50 and other Group 3A
Insecticides may exist through normal genetic variability in any insect population. The
resistant individuals can eventually dominate the insect population if Bugoff PC50 or other
Group 3A Insecticides are used repeatedly. The effectiveness of Bugoff PC50 on resistant
individuals could be significantly reduced. Since occurrence of resistant individuals is
difficult to detect prior to use, ChemAg Pty Ltd accepts no liability for any losses that may
result from the failure of Bugoff PC50 to control resistant insects.
Bugoff PC50 Residual Insecticide may be subject to specific resistance management
strategies. For further information contact your local supplier, ChemAg Pty Ltd
representative or local agricultural agronomist.
PROTECTION OF WILDLIFE, FISH, CRUSTACEA AND THE ENVIRONMENT
Dangerous to fish. Do not contaminate fish ponds, drains, rivers or streams with pesticide
or the used container. Remove or cover fish tanks before use. Do not discharge waste
product into waterways.
Avoid contact with food, food utensils, or places where food is prepared or stored.
BEFORE USE: Remove or cover all exposed food stuffs; cover all dishes and utensils,
and places where food is prepared or stored.
AFTER USE: Thoroughly ventilate treated area. Clean up thoroughly before
STORAGE, SPILLAGE AND DISPOSAL
Store in closed original containers, in cool well ventilated areas away from children,
animals, food and feedstuffs. Do not store for prolonged periods in direct sunlight. In case
of spillage, confine and absorb spilled product with absorbent material such as sand, clay
or cat litter and dispose of waste as indicated below. Do not re-use empty containers.
Triple or preferably pressure rinse containers before disposal, and add rinsings to tank
mix. On-site disposal of undiluted chemicals is unacceptable. Destroy empty containers
by breaking, crushing or puncturing them. Dispose of the containers at a local authority
landfill that does not burn its refuse. If there is no local authority landfill readily available in
your area, bury the containers a depth of 500mm or more in a disposal pit specifically
marked and setup for this purpose clear of waterways, vegetation and roots. Do not burn
empty containers or products.
Harmful if swallowed. May irritate the eyes and skin. Facial skin contact may cause
temporary facial numbness. Avoid contact with eyes and skin. Avoid inhaling vapour or
spray mist. When preparing spray, wear cotton overalls buttoned to the neck and wrist,
washable hat and elbow length PVC gloves and face shield or goggles. If product is in
eyes wash it out immediately with water. Wash hands after use and before eating,
Page 4 of 4
drinking or smoking, wash hands, arms and face thoroughly with soap and water. After
each day’s use, wash gloves, face shield, goggles and contaminated clothing.
If poisoning occurs, contact a doctor or Poisons Information Centre (Phone 131126).
EXCLUSION OF LIABILITY
This product as supplied is of a high grad and suitable for the purpose for which it is
expressly intended and must be used in accordance with the directions. The user must
monitor the performance of any product as climatic, geographical or biological variables
and/or developed resistance may affect the results obtained. No responsibility is accepted
in respect of this product, save for those non-excludable conditions implied by the Trade
Practices Act or any State or Federal legislation.
MATERIAL AND SAFETY DATA SHEETS
For further information refer to the Material Safety Data Sheets (MSDS).
NRA Approval No. 53380/1200
Date of Manufacture: